PicoKom Power Supply Unit with MF Passport 12 V - 220 mA, 1 Output

12 volt power supply unit (220 mA) that feeds equipment through the coaxial cable on the input, while passing through the TV signals. Used in the installation to power either a mast amplifier or a BOSS system. Compatible with amplifiers that have satellite input (MFmix), as the power supply unit detects and allows the current input to the LNB to be passed through on the output (voltage and tone) generated by the receiver

Stands out for
High-efficiency switched power supply that saves up to 40% in energy consumption
Very low energy consumption
Discreet design and ultra-compact design. Can be installed in 100 mm x 100 mm wall boxes
EasyF connection system
Robot-controlled fully automated manufacturing

Main features
Can be wall-mounted (screwed to the wall)
The MF mix function makes it possible to use the power supply in a satellite installation where the receiver will also power an LNB
Discover
EasyF connection: Easier and cheaper
EasyF is an innovative connection concept where the inner conductor of the coaxial cable is directly connected to the equipment, creating maximum reliability. Due to its design without an F-connector, the chassis can be made smaller and both cables can be connected/secured with a screw.

Time-saving: Speeding up the installation step is possible, without the need for traditional coaxial termination. At the same time, you avoid the hassle of screwing on connectors on the equipment, which can often be troublesome, especially in confined spaces
Connection reliability: A jumper holds the cable in place and prevents it from coming loose
Saves money: No extra connectors needed (neither F nor IEC)
Saves space: inputs and outputs are always on the same side to avoid bending the coaxial cable and to make working inside cabinets and wall sockets easier
Very easy three-step assembly: attaching or detaching the faceplate is all that is needed to connect both cables:

1. Loosen the distributor faceplate to access the connection
2. Tuck in the stripped coaxial cable
3. Close the front cover and tighten the screw to ensure good connection

Learn more about EasyF system reliability
With EasyF, the connection between the coaxial cable and the distributor is made through an automated system to make contact with both the shield and the inner conductor, without soldering or F-contact

Always like new: the service life of the device is extended by its design with EasyF
Reduced error rate: usually errors occur through cold soldering
Electromagnetic optimization: too high frequencies
Our strong commitment to the environment: pollution caused by the soldering process is eliminated and material consumption is reduced